On 11/04/2013 04:07 PM, Eric Bénard wrote:
Hi Wjatscheslaw,
Le Mon, 04 Nov 2013 16:00:49 +0100,
"Wjatscheslaw Stoljarski (Slawa)"
<wjatscheslaw.stoljarski@xxxxxxxxxxxx> a écrit :
On 11/04/2013 01:48 PM, Eric Bénard wrote:
Hi,
has anyone tried to start barebox on i.MX53 in 11 boot mode (serial
downloader)? I've tried on Freescale Loco board with pmic da9053, but
without success. In 00 boot mode (internal boot) works perfectly. U-Boot
works in both modes. DCD in u-boot and in barebox is the same. Even I
can turn on LEDs with DCD in 11 boot mode on Loco.
works fine here, what are you using to download barebox ?
I'm using imx-usb-loader. But I've tried MfgTool from Freescale too with
the same result.
ok sorry it's working here (on a custom board) in 11 boot mode but using
serial port to load it. IIRC USB was only tested in 00 as a fallback
when NAND flash is blank.
Eric
Sorry, I forget to mention that I'm using serial downloader via USB.
Hm... I've just tried to boot u-boot image in 11 mode, and from u-boot
start barebox. And it's works. Why then can I not boot barebox directly?
Wjatscheslaw
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
