Hi Wjatscheslaw, Le Mon, 04 Nov 2013 16:00:49 +0100, "Wjatscheslaw Stoljarski (Slawa)" <wjatscheslaw.stoljarski@xxxxxxxxxxxx> a écrit : > On 11/04/2013 01:48 PM, Eric Bénard wrote: > > Hi, > >> has anyone tried to start barebox on i.MX53 in 11 boot mode (serial > >> downloader)? I've tried on Freescale Loco board with pmic da9053, but > >> without success. In 00 boot mode (internal boot) works perfectly. U-Boot > >> works in both modes. DCD in u-boot and in barebox is the same. Even I > >> can turn on LEDs with DCD in 11 boot mode on Loco. > >> > > works fine here, what are you using to download barebox ? > I'm using imx-usb-loader. But I've tried MfgTool from Freescale too with > the same result. > ok sorry it's working here (on a custom board) in 11 boot mode but using serial port to load it. IIRC USB was only tested in 00 as a fallback when NAND flash is blank. Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox