On Sat, Aug 10, 2013 at 08:10:53AM +0400, Alexander Shiyan wrote: > Hello. > > USB functionality on PCM038 (PCM970) is broken again due > patch "Revert usb: chipidea-imx: Fix usb initialization". > > Board: Phytec phyCORE-i.MX27 > detected i.MX27 revision 2.1 > netconsole: registered as cs1 > mc13xxx-spi mc137830: Found MC13783 ID: 0x00009b [Rev: 3.1] > cfi_flash cfi_flash0: found cfi flash at c0000000, size 33554432 > nand: NAND device: Manufacturer ID: 0x20, Chip ID: 0x36 (ST Micro NAND 64MiB 1,8V 8-bit), 64MiB, page size: 512, OOB size: 16 > Bad block table found at page 131040, version 0x01 > Bad block table found at page 131008, version 0x01 > imxfb imxfb: i.MX Framebuffer driver > mdio_bus: miibus0: probed > No ULPI found. vid: 0x0000 pid: 0x0000 > pcm038: Using environment in NOR Flash > No ULPI found. vid: 0x0000 pid: 0x0000 > imx-usb imx-usb2: USB EHCI 1.00 > imx-mmc imx-mmc1: registered as imx-mmc1 > running /env/bin/init... > > After remove this patch, all works fine. Have you verified it really doesn't work? I get the 'No ULPI found' message aswell, but the ULPI phys are probed again during the 'usb' command and it then works here. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
