Hi Sascha, Le Tue, 2 Jul 2013 10:14:13 +0200, Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> a écrit : > On Mon, Jul 01, 2013 at 06:12:34PM +0200, Eric Bénard wrote: > > Hi, > > > > when upgrading from 2013.05.1 to 2013.06 on an i.MX35 I get the > > following log : > > > > - initial log : > > barebox 2013.05.1-00001-ga8e8785 #25 Mon Jul 1 17:12:14 CEST 2013 > > Board: Eukrea CPUIMX35 > > detected i.MX35 revision 2.1 > > netconsole: registered as cs1 > > nand: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V > > 8-bit), page size: 2048, OOB size: 64 > > mdio_bus: miibus0: probed > > imx-ipu-fb imx-ipu-fb: i.MX Framebuffer driver > > imx-esdhc imx-esdhc0: registered as imx-esdhc0 > > ehci ehci0: USB EHCI 1.00 > > malloc space: 0x87700000 -> 0x87efffff (size 8 MiB) > > running /env/bin/init... > > > > --> upgrade barebox : > > barebox 2013.06.0-00001-gf355cf4 #26 Mon Jul 1 17:57:52 CEST 2013 > > Board: Eukrea CPUIMX35 > > detected i.MX35 revision 2.1 > > netconsole: registered as cs1 > > nand: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V > > 8-bit), page size: 2048, OOB size: 64 > > nand: Bad block table not found for chip 0 > > nand: Bad block table not found for chip 0 > > imx_nand imx_nand: no BBT found. create one using the imx_nand_bbm > > command > > mdio_bus: miibus0: probed > > imx-ipu-fb imx-ipu-fb: i.MX Framebuffer driver > > imx-esdhc imx-esdhc0: registered as imx-esdhc0 > > ehci ehci0: USB EHCI 1.00 > > malloc space: 0x87700000 -> 0x87efffff (size 8 MiB) > > envfs: wrong magic on /dev/env0 > > no valid environment found on /dev/env0. Using default environment > > running /env/bin/init... > > no MAC address set for eth0. please enter the one found on your board: > > 00:12:34:56:78:90 saving environment > > > > Once I reset the board I can see that the env was not saved and I get > > prompted again for the MAC address. > > > > Any idea of what can be wrong there ? > > > > This board is configured in external boot from a 2k NAND (and was > > already using flash BBT), and the kernel and rootfs still run without > > any visible problem. > > Are you sure this happens between 2013.05.1 and 2013.06.0? The only > changes in the mtd stuff are: > > ae6f751 nand_base: sync flash detection functions with linux 3.9's code > c8af035 Merge branch 'for-next/misc' > 7c15fd1 NAND: imx: Fix memory leak > d8ee54f mtd: Nand: Use dev_add_param_bool for erasebad parameter > 7c6c61f treewide: Use dev_add_param_int_ro where possible > 973176d mtd: update NAND manufacturer names from the kernel > 4c2bdc8 nand_base: detect more ONFI flash > > So the only patches which seem to change something are from you ;) > I know and I feared I broke something :-( but I don't see where at the moment. I'll spend more time on this and provide more details shortly. Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
