Hi, when upgrading from 2013.05.1 to 2013.06 on an i.MX35 I get the following log : - initial log : barebox 2013.05.1-00001-ga8e8785 #25 Mon Jul 1 17:12:14 CEST 2013 Board: Eukrea CPUIMX35 detected i.MX35 revision 2.1 netconsole: registered as cs1 nand: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V 8-bit), page size: 2048, OOB size: 64 mdio_bus: miibus0: probed imx-ipu-fb imx-ipu-fb: i.MX Framebuffer driver imx-esdhc imx-esdhc0: registered as imx-esdhc0 ehci ehci0: USB EHCI 1.00 malloc space: 0x87700000 -> 0x87efffff (size 8 MiB) running /env/bin/init... --> upgrade barebox : barebox 2013.06.0-00001-gf355cf4 #26 Mon Jul 1 17:57:52 CEST 2013 Board: Eukrea CPUIMX35 detected i.MX35 revision 2.1 netconsole: registered as cs1 nand: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V 8-bit), page size: 2048, OOB size: 64 nand: Bad block table not found for chip 0 nand: Bad block table not found for chip 0 imx_nand imx_nand: no BBT found. create one using the imx_nand_bbm command mdio_bus: miibus0: probed imx-ipu-fb imx-ipu-fb: i.MX Framebuffer driver imx-esdhc imx-esdhc0: registered as imx-esdhc0 ehci ehci0: USB EHCI 1.00 malloc space: 0x87700000 -> 0x87efffff (size 8 MiB) envfs: wrong magic on /dev/env0 no valid environment found on /dev/env0. Using default environment running /env/bin/init... no MAC address set for eth0. please enter the one found on your board: 00:12:34:56:78:90 saving environment Once I reset the board I can see that the env was not saved and I get prompted again for the MAC address. Any idea of what can be wrong there ? This board is configured in external boot from a 2k NAND (and was already using flash BBT), and the kernel and rootfs still run without any visible problem. Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
