Hi all, I'm working on a custom design which has an imx53 and a 1GB NAND flash (Samsung k9k8g08u0d) via an 8 bit bus. So I added this imx_nand_platform_data structure with a .width=1, .hw_ecc=1 and .flash_bbt=1. The flash gets detected at startup (also loads the bootloader from it). nand: Manufacturer ID: 0xec, Chip ID: 0xd3 (Samsung NAND 1GiB 3,3V 8-bit), page size 2048, OOB size:64 but then nand: Bad block table not found for chip 0 nand: Bad block table not found for chip 0 etc and when I do imx_nand_bbm, I get: Bad eraseblock 0 at 0x00000000 Bad eraseblock 1 at 0x00020000 And for the rest UnCorrectable RS-ECC errors This is a barenew flash, so I suppose I should find a factory bad block table? I'm using the barebox 2013.05.1 stable release from git Grtz, Wouter _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
