Am 28.06.2012 12:43, schrieb Sascha Hauer: > On Thu, Jun 28, 2012 at 08:53:32AM +0200, Peter Kuennemann@Crane-Soft wrote: >>> >>> Has this been solved in the mean time? The above looks correct, I have >>> no idea what's wrong. ... >> However, I still cannot access the mmc from barebox. It would be enough to be able to >> read the mmc. I want to be able to store kernel or rootfs image updates on the mmc >> and flash them to either NAND or NOR after reboot to enable remote update services. >> >> Question: "How can I access the MMC from barebox (read only may be sufficient) > > The pcm043 currently does not have mmc support. You have to add this to > the board file: > > imx35_add_mmc0(NULL); > > or > > imx35_add_mmc1(NULL); > > depending on which port is routed to the slot. Also you have to setup > the iomuxer (you can probably copy the pin settings from the kernel). Of > course you also have to enable MMC support in the config. > > Sascha > Sascha I'ld like to pick up this thread again abd I hope that someone can give me the hint to help me out here. I managed to access the mmc applying your hints above. The card seem to appear correctly with all it's partitions: --- imx-esdhc@mci0: registered as mci0 mci@mci0: registered disk0 ehci@ehci0: USB EHCI 1.00 --- barebox:/ ls /dev defaultenv disk0 disk0.0 disk0.1 env0 full --- I am able to boot the kernel from NOR flash and use the mmc as rootfs. However I did not yet find a way to boot the kernel from the MMC. I set up the MMC with 255 heads, 63 sectors/track, 245 cylinders and formated partition 1 as VFAT and made it bootable. I then copied uImage to it. Partition 2 contains the rootfs which can be used when booting the kernel from flash. Barebox /env/config contains: (besides others) ... kernel_loc=disk rootfs_loc=disk rootfs_type=ext2 rootfs_part_linux_dev=mmcblk0p2 kernel_part=disk0.0 ... Trying to boot results in: booting kernel from /dev/disk0.0 and then followed by the barebox prompt. barebox:/ Kernel parameters are: console=ttymxc0,115200 video=mx3fb:CTP-CLAA070LC0ACW ip=dhcp root=/dev/mmcblk0p2 rootfstype=ext2 noinitrd rootwait mtdparts=physmap-flash.0:256k(barebox)ro,128k(bareboxenv),2M(kernel),-(root);:256k(barebox)ro,128k(bareboxenv),2M(kernel),-(root) A little help would be very much appreciated. Regards and many thanks for your support. Peter _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
