Hi, Is there a way to clear the nand bad block table? I'm not sure what happened, but I was playing around with barebox init and didn't register the nand device - then when I booted the kernel there were a stack of UBI errors. I assume this also did something to the bbt as subsequent barebox startups give a heap of bad block messages. Note not all blocks are bad - tested with nandtest and there's still some R/W going on. All the code I looked at seemed to indicate that once a block is marked bad you can't go back. Any ideas much appreciated. Cheers, Marc _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
