Hi George,
Le Tue, 21 Feb 2012 20:38:24 +0200,
George Stefan <stefan.george87@xxxxxxxxx> a écrit :
> Hello guys,
> After dd if=barebox.bin of=/dev/sdb bs=512 and dd if=arch/arm/boot/uImage
> of=/dev/sdb bs=512 seek=768 i am getting
>
> Board: Freescale i.MX53 LOCO registered netconsole as cs1 eth@eth0: got MAC
> address from EEPROM: 00:04:9F:01:B4:5B mci@mci0: No partition table found
> Cannot reset the SD/MMC interface Malloc space: 0x7df00000 -> 0x7fefffff
> (size 32 MB) Stack space : 0x7def8000 -> 0x7df00000 (size 32 kB) envfs:
> wrong magic on /dev/env0 no valid environment found on /dev/env0. Using
> default environment running /env/bin/init... Hit any key to stop autoboot:
> 1 phy0: Link is up - 100/Full T DHCP client bound to address
> 128.224.168.167 TFTP from server 128.224.168.11 ('zImage-loco' -> '/image')
>
> Wasn't the board suppose to boot from sd card by default?
>
it will if you configure it correctly (ie: check env/config and put
the right settings inside to tell it to get the kernel from disk
instead of tftp).
Eric
--
http://eukrea.com/en/news/104-2012
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
