After dd if=barebox.bin of=/dev/sdb bs=512 and dd if=arch/arm/boot/uImage of=/dev/sdb bs=512 seek=768 i am getting
Board: Freescale i.MX53 LOCO
registered netconsole as cs1
eth@eth0: got MAC address from EEPROM: 00:04:9F:01:B4:5B
mci@mci0: No partition table found
Cannot reset the SD/MMC interface
Malloc space: 0x7df00000 -> 0x7fefffff (size 32 MB)
Stack space : 0x7def8000 -> 0x7df00000 (size 32 kB)
envfs: wrong magic on /dev/env0
no valid environment found on /dev/env0. Using default environment
running /env/bin/init...
Hit any key to stop autoboot: 1
phy0: Link is up - 100/Full
T DHCP client bound to address 128.224.168.167
TFTP from server 128.224.168.11 ('zImage-loco' -> '/image')
Wasn't the board suppose to boot from sd card by default?
Also, i have another question. I want to replace
/* call start_barebox with its absolute address */
r = (unsigned int)&start_barebox;
__asm__ __volatile__("mov pc, %0" : : "r"(r));
&start_barebox with the actual address of the uImage practically to skip all the barebox part and
boot only with the minimal CPU and memory setup. What do you think?
Regards,
George.
_______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
