Hi Eric, Thanks for the quick response, what I would like to know is where is the actual entry point to the code, i.e. the "main()" function... I'm asking this because when I try to boot barebox on my board with the different NAND I don't even get a prompt on the serial line so I figured the image is not read properly. Thanks, Boaz. ________________________________________ From: barebox-bounces@xxxxxxxxxxxxxxxxxxx [barebox-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Eric Bénard [eric@xxxxxxxxxx] Sent: Wednesday, December 29, 2010 10:48 PM To: barebox@xxxxxxxxxxxxxxxxxxx Subject: Re: 4096 page NAND boot support on iMX35 PDK board Hi Boaz, On 29/12/2010 21:35, Boaz Ben-David wrote: > I just started using barebox on the iMX35 PDK and I have a bit of a problem. > My actual board is based on the PDK but with a slight change: the NAND chip is of newer generation and > has 4k page and 218 oob area. > I need to add support to boot from 4k pages in barebox and I can't seem to find any documentation on how to do that. > Can anyone point me in the right direction as to where to find this in the barebox code? > check in drivers/mtd/nand/nand_imx.c Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
