Hi, On Thu, Dec 2, 2010 at 3:20 PM, Orjan Friberg <of@xxxxxxxxxxxx> wrote: > Hi, > > We have successfully used Barebox as bootloader on one of our own boards > with an OMAP 3530. ÂSame board, but with a 3730 instead (and a few auxiliary > components changed) I'm getting completely garbled output on the serial > port. ÂI tried changing the baud rate from 115200 to 38400 and 19200 to no > avail. Not have omap3530 or other but have same issue with different board type. Problem was with clock setup for serial. Just an idea check if clock is correct according data sheet. Maybe 37xx differs from 35xx ;) > > Anyone here rambooted a 3730 with barebox? Â(Just to rule out that I need to > do any software changes.) > > When setting the board in boot mode "60" is printed on the serial port by > the boot ROM, the same way "40W" was printed by the 3530 so it's not like > the serial port isn't working at all. ÂI can bootstrap via either USB or > serial port. ÂWe're using the omap3530_beagle_per_uart_defconfig. > > > Thanks, > Orjan > > -- > Orjan Friberg > FlatFrog Laboratories AB > > _______________________________________________ > barebox mailing list > barebox@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/barebox > thanks, marek -- as simple and primitive as possible ------------------------------------------------- Marek Belisko - OPEN-NANDRA Freelance Developer Ruska Nova Ves 219 | Presov, 08005 Slovak Republic Tel: +421 915 052 184 skype: marekwhite icq: 290551086 web: http://open-nandra.com _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
