On Wed, Dec 16, 2009 at 07:57:21AM -0600, Bill Allison wrote: > Sorry - that was misleading. I've had > persistent_connection_after_error set on throughout my testing. I don't have that in my config file at all so I would guess it is at the default. > I get the same error as Brett only when the body of the post is much greater than that which causes the post to fail. > I only tried a large-ish document. We did observe the same strange limit that Bill has seen when we tested without the patch applied, under a certain "magic" threshold the document would upload - the threshold seemed to be around the 50k mark, over that threshold we would just get popups. > I'd like to correlate network traces with debug output and would appreciate suggestions as to which debug_options would include all possibly relevant info > I am a C coder and may have some time to do some debugging on this between christmas and new year so, Amos, if you have any thoughts or hints as to where to go looking I can certainly have a stab at it. -- Brett Lymn "Warning: The information contained in this email and any attached files is confidential to BAE Systems Australia. If you are not the intended recipient, any use, disclosure or copying of this email or any attachments is expressly prohibited. If you have received this email in error, please notify us immediately. VIRUS: Every care has been taken to ensure this email and its attachments are virus free, however, any loss or damage incurred in using this email is not the sender's responsibility. It is your responsibility to ensure virus checks are completed before installing any data sent in this email to your computer."
