-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 I'm not sure if I am doing this wrong or there's a setup problem. I'm installing under VM using loader with CTC's for IP traffic. I'm setting the firewall to 'medium' and allowing telnet access. After completing the installation and restarting the system, the only defined interface is lo and the networking setup is stuck on 'high'. To access telnet, I ifconfig ctc0, add a route, start in.telnetd manually and then can login. Using 'setup', I see that the firewall setting is on 'high' and any changes I make are not saved. Any idea's? Jay ENVIRONMENT install parmfile: root=/dev/ram0 ro ip=off DASD=200-20f ramdisk_size=35000 chandev=ctc0,0x7800,0x7801 CHANDEV=ctc0,0x7800,0x7801 HOST=linux3.aus.csc.com:ctc0:192.168.99.202:192.168.99.102:1492 DNS=127.0.0.1 SEARCHDNS=aus.csc.com RPMSERVER=ftp://20.17.37.222/home/zphelj/mnt/Rawhide/disc1 MOUNTS=/dev/dasdb1:/ SWAP=/dev/dasda INSTALL=default DTZ=CST6DST -----BEGIN PGP SIGNATURE----- Version: PGPfreeware 7.0.3 for non-commercial use <http://www.pgp.com> iQA/AwUBO8m1R1AsyTarzuzXEQJ3VQCg+eQZrNnQpY3XDJEdtXFgaDofS0EAnjhI X/18+nPiQHKERLkQTs32YIZZ =ehUe -----END PGP SIGNATURE-----
