OK, I know this command "rpm -Uvh --relocate /old=/new ... "
But I would you like to get back the prefix path in pre-installation
phase, and for that the only possibility is the interactive installation.
Do you know may be where I found the special documentation on
interactive rpm mode,
Thanks
Jeff Johnson wrote:
On Jan 26, 2006, at 9:04 AM, Hasan YAVUZ wrote:
Hello,
Is it possible to build an interactive rpm package.
It's possible, but strongly discouraged. I'll leave that to others ;-)
That means, I would like build a relocatable package but I'd like
find a way for don't give the path of installation as --prefix
(pathname)
I'd like to answer a questions as "Enter the path of package where
would you like to install: ?" in pre-installation phase and after
the rpm package install in the path given at the questions.
Is it possible to install rpm package with interactive mode.
Instead, invoke rpm as
rpm -Uvh --relocate /old=/new ...
to specify the relocation path for files.
If there are other occurences of the relocated path in, say, config
files, then
you will need to change those files in %post, or -- even better -- patch
the program to be as independent of installed (and possibly relocated)
path as possible.
hth
73 de Jeff
_______________________________________________
Rpm-list mailing list
Rpm-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/rpm-list
_______________________________________________
Rpm-list mailing list
Rpm-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/rpm-list
