Hi All
I am trying to configure GRUB for serial port access for my project. What I
want to do is ::
1. On boot , GRUB should always accept the password from the serial port
{ttyS0 }before continuing with booting .
2. I want this without dropping to the console in GRUB. I tried modifying
the /boot/grub/grub.conf by adding the following lines ::
serial --unit=0 --speed=9600
terminal serial
This is not making GRUB go automatically in the serial console . However ,
if I drop down to the console and then give these commands , then I am able
to communicate from another computer using minicom . I want to configure it
so that I can make the machine into a monitor-less machine .
Any help would be appreciated .
Thanks and Regards,
Karan Saberwal
--
Shrike-list mailing list
Shrike-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/shrike-list
