It might work, but only one question. Are you using Xen? []s Marcos On Fri, Jan 16, 2009 at 5:30 PM, Ugo Bellavance <ugob@xxxxxxxx> wrote: > Broekman, Maarten a écrit : > >> -----Original Message----- >>> From: redhat-list-bounces@xxxxxxxxxx [mailto: >>> redhat-list-bounces@xxxxxxxxxx] On Behalf Of Michael Simpson >>> Sent: Thursday, January 15, 2009 8:49 AM >>> To: General Red Hat Linux discussion list >>> Subject: Re: Traffic going to eth1 is goin >>> On 1/13/09, Ugo Bellavance <ugob@xxxxxxxx> wrote: >>> > Hi, >>> > >>> > I'm scratching my head on this one... >>> > >>> > I've configured a server with 2 network interfaces, eth0 and eth1. >>> eth0 = >>> > 192.168.2.211 and eth1 = 192.168.2.212. eth1 seemed to work >>> properly, but >>> > whenever I open a connection to 192.168.2.212, I see the traffic on >>> eth0. >>> you can't use 2 interfaces on the same subnet without bonding >>> you used to be able to years ago but it doesn't work now >>> note your default route >>> mike >>> >> >> That's not strictly true. You can use as many interfaces on the same >> subnet as you want and traffic to the IP addresses on those interfaces >> will come in initially on that interface, but then the local routing >> rules will force the traffic out the default route, which would appear >> to be eth0. You can change that behavior by setting up iptables rules >> that force the traffic over different interfaces depending on the source >> / destination of the traffic. >> > > Or use those 2 lines at the bottom of sysctl.conf and run sysctl -p > > net.ipv4.conf.all.arp_ignore=2 > net.ipv4.conf.all.arp_announce=1 > > I haven't found exactly what they mean, but I tested it and it works. > > Regards, > > Ugo > > > -- > redhat-list mailing list > unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/redhat-list > -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subjecthttps://www.redhat.com/mailman/listinfo/redhat-list
