On Thu, 2006-07-27 at 09:47 +0200, Stephane Branchoux wrote: > Hello, > > I use 2.6.9-34.0.2.ELsmp kernel on a Red Hat Enterprise Linux AS > release 4 box. > > # lspci |grep -i ethernet > 02:01.0 Ethernet controller: Intel Corporation 82546GB Gigabit Ethernet > Controller (rev 03) > > Eth1 card is connected on a 2950 cisco switch (on a giga port RJ45, > speed 1000 and duplex full ). > > When i use : > > ethtool -s eth1 speed 1000 duplex full autoneg off, then mii-tool -v > gives me : > > eth1: negotiated, link ok > product info: vendor 00:50:43, model 2 rev 5 > basic mode: autonegotiation enabled > basic status: autonegotiation complete, link ok > capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD > > How to activate 1000baseTx-FD ? > mii-tool is obsolete (even says so in the man page) use #/sbin/ethtool eth1 to get all the information you need. -- Karl Latiss <karl.latiss@xxxxxxxxxxxxx> Atvert Systems -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
