Ignore these questions unless network cards can be setup and
configure properly without kudzu. I think they should be
able to setup without kudzu.
The LED on the eth card cannot light-up. Something in the
card is not ok. Sorry for the previous email.
I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2.
I have 2 network cards in my computer but kudzu detected 1
card only. Why? ifconfig showed eth0 and lo only.
Then, I setup 2 interface in Network Configurator in X-Win
and reboot. Kudzu still didn't detect and 'modprobe: Can't
locate module eth1' at Bringing up eth1.
eth1 cannot be activated on startup but it can be activate
in X but cannot save.
So how do I configure the other network card? Both the
network cards are the same. Network Configuration in Text
Mode Setup can enter 1 IP only. dmesg shows 1 network card only.
Thanks in advance.
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
