just wondering if you enabled the second NIC in the BIOS??? Kishore Jalleda On 3/29/06, Ong Ying Ying <yingy@xxxxxxxxxxxx> wrote: > > I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2. > > I have 2 network cards in my computer but kudzu detected 1 > card only. Why? ifconfig showed eth0 and lo only. > > Then, I setup 2 interface in Network Configurator in X-Win > and reboot. Kudzu still didn't detect and 'modprobe: Can't > locate module eth1' at Bringing up eth1. > eth1 cannot be activated on startup but it can be activate > in X but cannot save. > > So how do I configure the other network card? Both the > network cards are the same. Network Configuration in Text > Mode Setup can enter 1 IP only. dmesg shows 1 network card only. > > Thanks in advance. > > > -- > redhat-list mailing list > unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/redhat-list > -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subjecthttps://www.redhat.com/mailman/listinfo/redhat-list
