I think you should check if the network card is functional if it is check that the slot if working also. Then do your test again -----Original Message----- From: redhat-list-bounces@xxxxxxxxxx [mailto:redhat-list-bounces@xxxxxxxxxx] On Behalf Of Ong Ying Ying Sent: Wednesday, March 29, 2006 4:16 PM To: redhat-list@xxxxxxxxxx Subject: Kudzu cannot detect 2nd network card I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2. I have 2 network cards in my computer but kudzu detected 1 card only. Why? ifconfig showed eth0 and lo only. Then, I setup 2 interface in Network Configurator in X-Win and reboot. Kudzu still didn't detect and 'modprobe: Can't locate module eth1' at Bringing up eth1. eth1 cannot be activated on startup but it can be activate in X but cannot save. So how do I configure the other network card? Both the network cards are the same. Network Configuration in Text Mode Setup can enter 1 IP only. dmesg shows 1 network card only. Thanks in advance. -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
