I just recompiled a new kernel, from 2.4.18-14 -> 2.4.23. I copied the old config from /boot/config-2.4.18-14 to /usr/src/linux-2.4.23/.config the did make mrproper make menuconfig (I read that this must be done on RH) make clean make dep make bzImage make modules make modules_install make install It all built great, but when I reboot it doesn't recongise the ethernet cards any more before with old kernel Broadcom Gigabit Ethernet Driver bcm5700 with Broadcom NIC Extension (NICE) ver. 4.0.2 (09/18/02) divert: allocating divert_blk for eth0 PCI: Assigned IRQ 11 for device 03:06.0 eth0: Broadcom BCM5701 found at mem fcf10000, IRQ 11, node addr 00065bf38c0e eth0: Broadcom BCM5701 Integrated Copper transceiver found eth0: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum ON, 802.1Q VLAN ON divert: allocating divert_blk for eth1 PCI: Assigned IRQ 10 for device 03:08.0 eth1: Broadcom BCM5701 found at mem fcf00000, IRQ 10, node addr 00065bf38c0f eth1: Broadcom BCM5701 Integrated Copper transceiver found eth1: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum ON, 802.1Q VLAN ON bcm5700: eth0 NIC Link is UP, 100 Mbps half duplex bcm5700: eth1 NIC Link is UP, 100 Mbps half duplex ip_conntrack (4095 buckets, 32760 max) now with new kernel Dec 5 10:07:55 network: Setting network parameters: succeeded Dec 5 10:07:56 network: Bringing up loopback interface: succeeded Dec 5 10:07:56 ifup: bcm5700 device does not seem to be present, delaying eth0 initialization. Dec 5 10:07:56 network: Bringing up interface eth0: failed Dec 5 10:07:56 ifup: bcm5700 device does not seem to be present, delaying eth1 initialization. Dec 5 10:07:56 network: Bringing up interface eth1: failed Can anyone give me some ideas ? Thanks -- -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
