I should have done something else this afternoon, but anyway, I was inspired to write up this text for the wiki. Comments welcome. Keld Bottlenecks There can be a number of bottlenecks other than the disk subsystem that hinders you in getting full performance out of your disks. One is the PCI bus. Older PCI bus has a 33 MHz cycle and a 32 bit width, giving a maximum bandwidth of about 1 Gbit/s, or 133 MB/s. This will easily cause trouble with newer SATA disks which easily gives 70-90 MB/s each. So do not put your SATA controllers on a 33 MHz PCI bus. The 66 MHz 64-bit PCI bus is capable of handling about 4 Gbit/s, or about 500 MB/s. This can also be a bottleneck with bigger arrays, eg a 6 drive array will be able to deliver about 500 MB/s, and maybe you want also to feed a gigabyte ethernet card - 125 MB/s, totalling potentially 625 MB/s on the PCI bus. The PCI-Express bus v1.1 has a limit of 250 MB/s per lane per dirction, and that limit can easily be hit eg by a 4-drive array. Many SATA controllers are on-board and do not use the PCI bus. Anyway bandwidth is limited, but it is probably different from motherboard to motherboard. On board disk controllers most likely have a bigger bandwidth than IO controllers on a 32-bit PCI 33 MHz, 64-bit PCI 66 MHz, or PCI-E x1 bus. Having a RAID connected over the LAN can be a bottleneck, if the LAN speed is only 1 Gbit/s - this limits the speed of the IO system to 125 MB/s by itself. Classical bottlenecks are PATA drives placed on the same DMA channel, or the same PATA cable. This will of cause limit performance, but it should work, given you have no other means of connecting your disks by. Also placing more than one element of an array on the same disk hurts performace seriously, and also gives redundancy problems. A classical problem is also not to have enabled DMA transfer, or having lost this setting due to some problem, including not well connected cables, or setting the transfer speed to less than optimal. RAM sppec may be a bottleneck. Using 32 bit RAM - or using a 32 bit operating system may double time spent reading and writing RAM. CPU usage may be a bottleneck, also combined with slow RAM or only using RAM in 32-bit mode. BIOS settings may also impede your performance. -- To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html