On Thu, Jun 26, 2008 at 08:21:49AM -0500, Jon Nelson wrote: > A few months back, I converted my raid setup from raid5 to raid10,f2, > using the same disks and setup as before. > The setup is an AMD x86-64, 3600+ dual, making use of three 300 GB SATA disks: > > The current raid looks like this: > > md0 : active raid10 sdb4[0] sdc4[2] sdd4[1] > 460057152 blocks 64K chunks 2 far-copies [3/3] [UUU] > bitmap: 1/439 pages [4KB], 512KB chunk, file: /md0.bitmap > > /dev/md0: > Version : 00.90.03 > Creation Time : Fri May 23 23:24:20 2008 > Raid Level : raid10 > Array Size : 460057152 (438.74 GiB 471.10 GB) > Used Dev Size : 306704768 (292.50 GiB 314.07 GB) > Raid Devices : 3 > Total Devices : 3 > Preferred Minor : 0 > Persistence : Superblock is persistent > > Intent Bitmap : /md0.bitmap > > Update Time : Thu Jun 26 08:16:52 2008 > State : clean > Active Devices : 3 > Working Devices : 3 > Failed Devices : 0 > Spare Devices : 0 > > Layout : near=1, far=2 > Chunk Size : 64K > > UUID : ff4e969d:2f07be4e:8c61e068:8406cdc0 > Events : 0.1670 > > Number Major Minor RaidDevice State > 0 8 20 0 active sync /dev/sdb4 > 1 8 52 1 active sync /dev/sdd4 > 2 8 36 2 active sync /dev/sdc4 > > As you can see, it's comprised of 3x 292 MiB partitions (the other > partitions are unused or used for /boot, so no run-time I/O). > > Individually, the disks are capable of some 70 MB/s (give or take). > The raid5 would take 2.5 hours to run a "check". > The raid10,f2 takes substantially longer: > > Jun 23 02:30:01 turnip kernel: md: data-check of RAID array md0 > Jun 23 07:17:46 turnip kernel: md: md0: data-check done. > > Whaaa? 4.75 hours? That's 28MB/s end-to-end. That's about 40% of > actual disk speed. I expected it to be slower but not /that/ much > slower. What might be going on here? It could be random IO, sort of. I am not sure how the checking is done, but if it does it in sequential block order there will be a lot of head moving because of the striping layout of raid10,f2. This could be improved if the checking could take one stripe layer at a time. Maybe that is not possible if what is checked is that contents of one part of the mirror is equal to the other. Another strategy could then be to check large chunks of data a time, say 20 MB - then quite some stripe reading should be achieved. best regards keld -- To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
