Eddie Johnson wrote: > I installed Suse Linux Professional 8 on a HP Netserver LC3 PII/450. An > AHA-2940 UW Scsi host adapter with a AIC-78XX Scsi Protocol Chip/50 pin > high density scsi-2 control. I have a raid (3 drives) off the host No, you have an HP NetRaid Adapter (Aka AMI megaraid) > adapter and a 80 gig scsi drive off the mother board. After launching > yast2 the first raid has the following device: LD0 raid 5 34730R: > device_name /dev/sda, vendor megaraid. Disk two (80 gig drive) has LD1 > raid 0 70006R: device name /dev/sdb vendor the same as above. There was > no raidtab file so I created one with the following: > ......... > If I read this correctly both are inactive when it should be stating > that they are active. At this point I am baffled any suggestions or > possible directions would greatly be appreciated. you don't need md, mkraid or such, if you want to configure your hw raid just press Ctrl-M at boot or start the server from the Navigator CD L. - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
