'Twas brillig, and John Frankish at 21/04/10 07:15 did gyre and gimble: > OK, now that's clear, I tried the following with: > > $ cat /proc/asound/cards 0 [Intel ]: HDA-Intel - HDA Intel > HDA Intel at 0xefebc000 irq 28 > > kernel 2.6.33.2 > > pulseaudio-0.9.21 patched > > Subject: [PATCH] udev: handle sound cards with both modem and audio > properly Subject: [PATCH] udev: rework modem detection a bit > > [copy 90-pulseaudio.rules /etc/udev/rules.d] FWIW, you probably want a lot more patches than that. Basically anything that's in the stable-queue git branch. What distro is this? Generally speaking your distro maintainer will make sure you have a working setup OOTB. > Basically module-udev-detect does not find any sound devices. If I > use module-detect, then the sound device is found, but > gstreamer-properties does not show any pulseaudio source. So it should just show a generic "PulseAudio Sound Server". If you don't have this, then have you got the necessary packages installed. e.g. gstreamer-pulse or gstreamer0.10-pulse or similar? You are not expected to see all the individual devices Pulse knows about, just a generic "PulseAudio" listing. If you don't have this listing in gstreamer-properties, then you're gstreamer was perhaps built without PA support or you don't have all the necessary packages installed as mentioned above. > I also tried after pairing Bluetooth a2dp headphones - > module-bluetooth-discover finds the headphones, but > gstreamer-properties does not show any pulseaudio source and thus I > cannot use rhythmbox to play to the headphones. As said above, you do not set things up like this in gstreamer. It should just be configured to use "pulseaudio" generally. You then use a real-time PA mixer app like pavucontrol or kmix from KDE trunk. These programs list the active "streams" (e.g. what is currently being played in Rhythmbox) and allow you to move the stream to the device of your choice. > I can set the > headphones as the default alsa device in .asoundrc, but this bypasses > pulseaudio and is not the object of the exercise. As you note, this is very much not the way to do things :p > ""). D: cli-command.c: Checking for existance of > '/usr/local/lib/pulse-0.9.21/modules/module-udev-detect.so': success > I: module-udev-detect.c: Found 0 cards. I: module.c: Loaded > "module-udev-detect" (index: #4; argument: ""). Something seems wrong here... I suspect your udev setup is somehow broken but I'm not an expert WRT udev so can't really say for sure. Col -- Colin Guthrie gmane(at)colin.guthr.ie http://colin.guthr.ie/ Day Job: Tribalogic Limited [http://www.tribalogic.net/] Open Source: Mandriva Linux Contributor [http://www.mandriva.com/] PulseAudio Hacker [http://www.pulseaudio.org/] Trac Hacker [http://trac.edgewall.org/]
