Hello , I am trying to detect an i2c device A on i2c1 line on one of the Arm Cortex A7 platform but not able to see any device on a given address ( 0x3d) . Is there any parameters of i2c which i can change like rise/fall time , timeout etc in a device tree or kernel source and re test it? I have tried changing the i2c speed from 100KHz to 400 KHz but no success. I have even tried removing the 1.5K pull ups on the i2c lines but no result. So I wanted to know on what factors i2cdetect may not probe the device or show it on the hex dump. What parameters of i2c driver i can tinker and where? Is Platform dts is the only file i can modify and test with? Kernel is 5.51 . There are other 2-3 devices on the same lines which responds to i2cdetect with correct address but not this device (0x3D) . Its i2c address is also different from the current devices. Regards, R _______________________________________________ Kernelnewbies mailing list Kernelnewbies@xxxxxxxxxxxxxxxxx https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies