On Mon, Jul 27, 2009 at 7:13 AM, Denis Borisevich<dennisfen@xxxxxxxxx> wrote: > Hi! > I have driver for PCI serial board, it compiles as a module, loads and > works fine. Now it exists as a several files outside the kernel source > tree. I want to integrate this code within the kernel source tree: I > want it to exist as some files inside the kernel source, I want to be > able to select this driver in kernel config and so on. So can any one > provide me any instructions to achieve this task (I hope it is not > very difficult) or point to any online documents, etc.? You will need a Makefile and Kconfig like any other kernel module. Look at the source for examples. Then put your source files, including the Makefile and Kconfig in a relevant (new) subdirectory and then try make xconfig. Rinse. repeat. Maybe <kernel_source>/Documentation/kbuild is a good place to start reading? HTH, -Bob -- To unsubscribe from this list: send an email with "unsubscribe kernelnewbies" to ecartis@xxxxxxxxxxxx Please read the FAQ at http://kernelnewbies.org/FAQ
