Two questions:
1) How can I get my linux boxes to see and communicate properly with my
D-Link router?
D-Link's usually have a netmask of 255.255.255.0 -- and an IP of
192.168.0.1, and since your linux boxes are 192.168.1.x, they are outside of
the netmask range and the dlink ignores them.
Set the LAN netmask on the dlink to 255.255.0.0, or change it's IP to
192.168.1.1, or change your linux boxes to 192.168.0.x..
Also, the dlinks default to have a DHCP server running on them -- so you
could set your linux boxes to use DHCP to autoconfigure an IP, but then you
wouldn't always know what IP they would be. (They would probably start at
around 192.168.0.100 or so.)(To try dhcp, just type dhcpcd and press enter
and wait. dhcpcd stands for "Dynamic Host Configuration Protocol Client
Daemon. dhcpcd requests to be assigned an IP, netmask, default gateway, and
DNS from the dlink.)
2) My linux boxes were using a dialup modem serial port to connect to the
Internet. How can I change my connection from using the dialup modem to
now go through the router to access the high speed connection?
After changing the IP or netmask as above, just set your default route to be
192.168.0.1 (or whatever you set the LAN ip to on the dlink.)
I don't know what distro you use, so I don't know which network
configuration utility you would use, but to test it, you could type these on
one of the linux boxes:
ifconfig eth0 192.168.0.2 netmask 255.255.0.0
route add default gw 192.168.0.1
Of course you might type route -n (then press the ENTER key) to make sure
there isn't already a default route.
You'll also need to set up a DNS server IP. You can use whatever network
configuration tool you have or like, or you may be able to just edit
/etc/resolv.conf and add the line:
nameserver 192.168.0.1
before any other 'nameserver' lines.
Hope this helps.
-Jesse
----- Original Message -----
From: <martinh@xxxxxxxxxxxxx>
To: <netfilter@xxxxxxxxxxxxxxxxxxx>
Cc: <martinh@xxxxxxxxxxxxx>
Sent: Thursday, May 25, 2006 9:00 AM
Subject: Linux box to D-Link router/bridge/access connection question
I just got a D-Link wireless router connected to high speed Internet access
via a cable modem.
I have a Windoze XP laptop with wireless network card that communicates
properly with the wireless router and I can make a high speed Internet
connection.
My linux box1 is connected into port two of the router.
My linux box2 is connected to port 3.
My two linux boxes can see each other connected into the ports of the
wireless router.
But I can not get my linux boxes to see the D-Link router!
D-Link address is 192.168.0.1
My linux boxes are 192.168.1.2 and 192.168.1.50
Two questions:
1) How can I get my linux boxes to see and communicate properly with my
D-Link router?
2) My linux boxes were using a dialup modem serial port to connect to the
Internet. How can I change my connection from using the dialup modem to
now go through the router to access the high speed connection?
Thank you for you help.
-Martin
