Hi Pete,
I used a quite different board (STB810), but it's
based on the same board dependent code as JBS (i.e
arch/mips/philips/pnx8550/jbs). I haven't
worked with
JBS board and I'm not sure if slot=10 is needed for
that, but it's really necessary for STB810.
The JBS has only 3 pci slots and I tested all three.
So the fourth one you added won't do any damage but
it's not quite right either.
I also has another question - Could you please
advice: shall I create a different
arch/mips/philips/pnx8550/stb810
and add MACH_PHILIPS_STB810 ID and defconfig
or I can use exiting JBS one?
Is anything else different that would justify the new
directory? If not, perhaps we just need an STB board
selection in arch/mips/Kconfig, a defconfig, and an
ifdef around that pci slot you sent.
The are only 3 small file in the arch/mips/philips/pnx8550/jbs directory:
1) board_setup.c is the same for STB810
2) init.c may be needs cosmetic changes to identify the board:
"Philips PNX8550/JBS" -> "Philips PNX8550/STB810"
MACH_PHILIPS_JBS -> MACH_PHILIPS_STB810
I'm not sure are they really needed?
3) irq.map needs change to add slot 10 and remove slot 17 for STB810 board.
That's all :)
BTW, regarding your serial driver patch ... I have one
outstanding change (small) I still have to make, as
requested by rmk. Mind if I forward that email to you
so you can take care of it :)?
Yes, please.
Vladimir