On Thu, Jan 01, 2015 at 04:15:46PM -0800, Mark Hansen wrote: > I have a new CentOS 7.0 system running on an ASUS M5A97 R2.0 motherboard and > am having a hard time getting the configuration correct. > > I started by running sensors-detect, which seemed to work. I decided I need > the "it87" module and added that to /etc/sysconfig/lm_sensors. > > I then took a configuration from the lm-sensors Wiki: > > http://lm-sensors.org/wiki/Configurations/Asus/M5A97-Pro > > Note: I realize this is the Pro and not the R2.0. > > I took the values shown on the BIOS monitoring screen and applied various labels > and min/max settings to what I thought matched in the sensors output. It all looks > good (assuming I did things correctly) except that it's showing one voltage output > that is not on the BIOS screen. This value is outside the min/max range and so it > shows as "ALARM" and I can't figure out how to get rid of it. > > The sensors output is shown below. The specific value I'm talking about > is called 3VSB. How can I remove this from sensors or set the min/max values > for it? > 3VSB is in7, so you can either configure "ignore in7" or configure in7_min and in7_max. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
