On 11/3/2012 11:43 AM, Hans de Goede wrote:
Hi,
Now a days not really, since there is little ISA stuff left in a
modern PC, and what
is there usually is detected fine without isapnp too, since it has
been at the
same isa address since the beginning of time (ie serial ports, if
you're lucky enough
to have a serial port on your motherboard). However if in the future
you think:
"hey why is Linux not seeing my foobar hardware" where by foobar is
something
ancient like say a floppy controller, try removing the option. Note
this is all
AFAIK, this is veering away a bit from my area of expertise (which is
certain hwmon
chips and usb).
> Is it possible there is a CMOS option that will disable the BIOS use
of this resource?
Not likely.
Regards,
Hans
Ok. I won't worry about it then. The wiki says that custom
configurations should be sent to the mailing list. Below is the
configuration I have that seems to work. Hopefully this will help
someone else.
Thanks,
Logan
chip "f71882fg-*"
### Voltages
#Not sure about in2. Reading changes with change to NB voltage
#and Vcore voltage
label in1 "Vcore"
label in2 "NBcore"
label in3 "+5V"
label in4 "+12V"
label in5 "5VSB"
label in6 "VDIMM"
compute in2 @ * (16/8), @ / (16/8)
compute in3 @ * (42/8), @ / (42/8)
compute in4 @ * (88/8), @ / (88/8)
compute in5 @ * (42/8), @ / (42/8)
compute in6 @ * (16/8), @ / (16/8)
set in1_min 0.7
set in1_max 1.5
set in2_min 1.2 * 0.95
set in2_max 1.2 * 1.05
set in3_min 5 * 0.95
set in3_max 5 * 1.05
set in4_min 12 * 0.95
set in4_max 12 * 1.05
set in5_min 5 * 0.95
set in5_max 5 * 1.95
set in6_min 1.5 * 0.95
set in6_max 1.5 * 1.95
###Temps
label temp1 "CPU Temp"
label temp2 "SYS Temp1"
label temp3 "SYS Temp2"
###Fans
#Fan4 doesn't exist on this motherboard
ignore fan4
label fan1 "CPU Fan"
label fan2 "SYS Fan1"
label fan3 "SYS Fan2"
set fan1_min 500
set fan2_min 500
set fan3_min 500
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
