On Thu, 9 Feb 2012 08:57:23 -0800, Guenter Roeck wrote: > Add description of pwm[1-4]_start_output, pwm[1-4]_step_output, > pwm[1-4]_stop_output, and pwm[1-4]_max_output attributes to driver > documentation. Would be nice to have these standardized at some point... But meanwhile I agree it's best described in the driver documentation file. > Signed-off-by: Guenter Roeck <guenter.roeck@xxxxxxxxxxxx> > --- > Documentation/hwmon/w83627ehf | 5 +++++ > 1 files changed, 5 insertions(+), 0 deletions(-) > > diff --git a/Documentation/hwmon/w83627ehf b/Documentation/hwmon/w83627ehf > index 3f44dbd..ea75fe4 100644 > --- a/Documentation/hwmon/w83627ehf > +++ b/Documentation/hwmon/w83627ehf > @@ -143,6 +143,11 @@ pwm[1-4]_min_output - minimum fan speed (range 1 - 255), when the temperature > pwm[1-4]_stop_time - how many milliseconds [ms] must elapse to switch > corresponding fan off. (when the temperature was below > defined range). > +pwm[1-4]_start_output-minimum fan speed (range 1 - 255) when spinning up > +pwm[1-4]_step_output- rate of fan speed change (1 - 255) > +pwm[1-4]_stop_output- minimum fan speed (range 1 - 255) when spinning down > +pwm[1-4]_max_output - maximum fan speed (range 1 - 255), when the temperature > + is above defined range. > > Note: last two functions are influenced by other control bits, not yet exported "last two" should probably become "last six". > by the driver, so a change might not have any effect. Other than this: Acked-by: Jean Delvare <khali@xxxxxxxxxxxx> -- Jean Delvare _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
