On Fri, 10 Jun 2011 02:31:14 +0200 (CEST), tux99-lmsens@xxxxxxxxxxx wrote: > > Hi, > I just wanted to contribute my sensors.conf for the Sapphire Pure Fusion > Mini E350 motherboard. I'm quite confident about the accuracy of the > config, I spent a fair amount of time verifying each bit. > I also posted this here: > http://scientificlinuxforum.org/index.php?showtopic=415 > > #---------------------------------- > # lm-sensors config for Sapphire Pure Fusion Mini E350 board > > chip "f71808e-*" > > label in0 "VCC +3.3V" > # E-350 Vcore range is ~ 0.5V-1.35V (lowest idle state to max load) > label in1 "CPU Vcore" > ignore in2 > label in3 "DDR3 VDIMM" > label in4 "FCH +1.1V" > label in5 "PCIe +1.8V" > label in7 "3VSB +3.3V" > label in8 "VBAT +3.0V" > > compute in0 @*2, @/2 > compute in3 (@ * 1.465), (@ / 1.465) This is surprising. DDR3 would be +1.5V, which fits on 8 bit with a 8 mV ADC, so no scaling should be needed. Do you have a reason to believe that DDR3 voltage is actually monitored on your system? > compute in7 @*2, @/2 > compute in8 @*2, @/2 > > label fan1 "CPU Fan" > label fan2 "SYS Fan" > > ignore fan3 > > label temp1 "SYS Temp1" > label temp2 "SYS Temp2" > > chip "k10temp-*" > > label temp1 "CPU Temp" I've put your file at: http://www.lm-sensors.org/wiki/Configurations/Sapphire/PureFusionMiniE350 Thanks for your contribution. -- Jean Delvare _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
