On 11/18/10 11:22, Ira W. Snyder wrote:
On Thu, Nov 18, 2010 at 10:16:27AM -0500, Richard Retanubun wrote:
Some bits in the fault register can be useful to differentiate
between a planned reset (reboot) or an unplanned reset (pwr-loss).
The EN bit can be used for this detection when a board's planned
reboot action toggles the EN bit and cuts the regulated voltage
(but keeping the hotswap device alive), meanwhile an unplanned
reset (pwr-loss) will not have the EN bit set because even the
hotswap device got powered off.
So, before clearing the fault register at boot, dump the contents
of the fault register so that other tools can use it as a forensic
marker to differentiate events that preceeds this boot.
---
Hi Ira and Jean,
Not sure if there is a mailing list for hwmon, I did not see it,
the MAINTAINERS file did not help, but git history shows that you two
are the people who are working on this driver in the patch.
Hi Ira,
Thanks for the speedy reply.
The mailing list you wanted was lm-sensors@xxxxxxxxxxxxxxx
Thanks, was not sure, cc-ed now.
As for the patch, I think it would be more likely to be accepted with a few changes:
- only print the register if certain bits are set
- don't print the hex value, print something meaningful
Sure, but which bits? almost all of them means something to someone depending on how the chip is used.
This is why I opted to a more "interpretation-neutral" hex-value.
I also chose "FReg" because some tools may catch the word "Fault" and flag this dump as something scary :)
I can do basic bit to string mapping using the register names,
something like (GPIO3, GPIO2, FET, EN, PwrBad, OverCurrent, UnderVoltage, OverVoltage)
in the case where all the bits are set, is this what you have in mind?
Also, another feedback I got was to not only print this at device_probe, but also
save the initial value and display it as a device attribute exposed via sysfs,
do you have any comments on this approach?
Btw, in your commit, you cleared the bits because of spurious bits being set at boot,
does this observation pertain only to the [Over|Under][Current|Voltage] bits
or does other bits also tends to be spurious? just curious.
Thanks again for your time.
- Richard
FYI, the reason the register is cleared is to avoid displaying power-on
faults to the user. Would it be more useful to clear all bits except the
EN bit?
Ira
drivers/hwmon/ltc4215.c | 4 ++++
1 files changed, 4 insertions(+), 0 deletions(-)
diff --git a/drivers/hwmon/ltc4215.c b/drivers/hwmon/ltc4215.c
index 40ebdfc..fa18e40 100644
--- a/drivers/hwmon/ltc4215.c
+++ b/drivers/hwmon/ltc4215.c
@@ -278,6 +278,10 @@ static int ltc4215_probe(struct i2c_client *client,
i2c_set_clientdata(client, data);
mutex_init(&data->update_lock);
+ /* Print fault register status at boot, before clearing it */
+ dev_info(&client->dev, "FReg: 0x%0x\n",
+ i2c_smbus_read_byte_data(client, LTC4215_FAULT));
+
/* Initialize the LTC4215 chip */
i2c_smbus_write_byte_data(client, LTC4215_FAULT, 0x00);
--
1.7.2.3
_______________________________________________
lm-sensors mailing list
lm-sensors@xxxxxxxxxxxxxx
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
