Hi Karl, On Wed, 02 Sep 2009 12:02:47 -0500, Karl Schmidt wrote: > Jean Delvare wrote: > > Please try this too, for example set in0_max to 1.0V and see if > > in0_alarm gets raised. > > no joy.. > #sensors > k8temp-pci-00c3 > Adapter: PCI adapter > Core0 Temp: +24.0°C > > lm85b-i2c-0-2e > Adapter: SMBus nForce2 adapter at 1c00 > V1.5: +1.30 V (min = +0.00 V, max = +1.00 V) > VCore: +1.42 V (min = +0.00 V, max = +2.99 V) > V3.3: +3.33 V (min = +0.00 V, max = +4.38 V) > V5: +5.08 V (min = +0.00 V, max = +6.64 V) > V12: +12.06 V (min = +0.00 V, max = +15.94 V) > CPU_Fan: 7826 RPM (min = 8000 RPM) > Fan2: 8181 RPM (min = 0 RPM) > Fan3: 7917 RPM (min = 0 RPM) > Fan4: 7929 RPM (min = 0 RPM) > CPU Temp: +39.0°C (low = -127.0°C, high = +127.0°C) > Board Temp: +28.0°C (low = -127.0°C, high = +127.0°C) > Remote Temp: +24.0°C (low = -127.0°C, high = +127.0°C) > cpu0_vid: +1.550 V > > (...) > > Does "alarms" read 0 as well? > > yes - all alarms files read zero > /sys/class/hwmon/hwmon1/device# cat alarms > 0 OK, this rules out a user-space issue. The problem must be either at the hardware level or in the lm85 driver. Please unload the lm85 driver temporarily, load the i2c-dev driver, and provide the output of the following command: i2cdump 0 0x2e This will dump all the device registers. I will then check against the datasheet and see if I spot anything. -- Jean Delvare _______________________________________________ lm-sensors mailing list lm-sensors@xxxxxxxxxxxxxx http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
