--On Friday, June 27, 2003 20:34 -0400 "Mark D. Studebaker " <mds at paradyne.com> wrote: This does get a sensor running; it reports CPU temps of ~60 C. When I finally had a chance to take the server down and check via the BIOS, it reported temps in the mid-30s. The voltages and fan speeds reported via i2c seem to be reasonable numbers. > try modprobing i2c-isa then it should work. > > Charles Bailey wrote: >> Tried CVS i2c lk-24 and lm_sensors2 per your reply. Both build and >> install fine. ./prog/detect/sensors-detect again picks up the AMD768, >> but fails loading i2c-amd756, apparently because it's now in >> i2c/busses. It also fails to locate the 627HF, both before and after >> the amd756 module is loaded manually (not that that should matter, >> afaict). If I load modules manually, yielding >> >> Module Size Used by Not tainted >> w83627hf 13044 0 (unused) >> i2c-proc 8116 0 [w83627hf] >> i2c-amd756 3848 0 >> i2c-dev 4992 0 >> i2c-core 20164 0 [w83627hf i2c-proc i2c-amd756 i2c-dev] >> >> I still have no luck: >> >> [bailey at XXX ~]% /usr/local/bin/sensors >> No sensors found! >> >> If I add the eeprom chip driver, I get little more: >> >> [bailey at XXX ~]% /usr/local/bin/sensors >> eeprom-i2c-0-50 >> Adapter: SMBus AMD75x adapter at 06e0 >> Algorithm: Non-I2C SMBus adapter >> Memory type: DDR SDRAM DIMM SPD >> Memory size (MB): 512 >> >> eeprom-i2c-0-51 >> Adapter: SMBus AMD75x adapter at 06e0 >> Algorithm: Non-I2C SMBus adapter >> >> [bailey at XXX ~]% >> >> I'm happy to test changes or provide additional data if that would help. >> >> -- >> Regards, >> Charles Bailey < baileych _at_ mail _dot_ med _dot_ upenn _dot_ edu > >> Fellow, Pediatric Hematology/Oncology >> Children's Hospital of Philadelphia/University of Pennsylvania >> -- Regards, Charles Bailey < baileych _at_ mail _dot_ med _dot_ upenn _dot_ edu > Fellow, Pediatric Hematology/Oncology Children's Hospital of Philadelphia/University of Pennsylvania
