Am 03.02.25 um 03:40 schrieb Ping-Ke Shih:
Ezra Buehler <ezra@xxxxxxxx> wrote:
From: Ezra Buehler <ezra.buehler@xxxxxxxxxxxxxxxxxx>
This allows the driver to be used in wireless access point mode on the
AT91SAM9G25-based GARDENA smart Gateway.
Unfortunately, the data throughput in AP mode appears to be lower than
with the vendor driver (or in STA mode). Especially when sending, the
data rate is significantly lower. My measurements performed with iperf3
and an Edimax EW-7811Un (VID: 7392, PID: 7811) showed a maximum TX rate
of about 4 Mbits/sec compared to the ~24 Mbits/sec measured with the
rtl8192cu driver.
Although the performance might be good enough for our use case, this is
something that should be further looked into.
Signed-off-by: Ezra Buehler <ezra.buehler@xxxxxxxxxxxxxxxxxx>
1 patch(es) applied to rtw-next branch of rtw.git, thanks.
Is there a reason for not setting macid in rtl8xxxu_fill_txdesc_v1() and
rtl8xxxu_update_rate_mask() like it was done for the gen2 case?
4828f572b20b wifi: rtl8xxxu: Enable AP mode for RTL8192CU (RTL8188CUS)
---
https://github.com/pkshih/rtw.git
