Ezra Buehler <ezra@xxxxxxxx> wrote: > From: Ezra Buehler <ezra.buehler@xxxxxxxxxxxxxxxxxx> > > This allows the driver to be used in wireless access point mode on the > AT91SAM9G25-based GARDENA smart Gateway. > > Unfortunately, the data throughput in AP mode appears to be lower than > with the vendor driver (or in STA mode). Especially when sending, the > data rate is significantly lower. My measurements performed with iperf3 > and an Edimax EW-7811Un (VID: 7392, PID: 7811) showed a maximum TX rate > of about 4 Mbits/sec compared to the ~24 Mbits/sec measured with the > rtl8192cu driver. > > Although the performance might be good enough for our use case, this is > something that should be further looked into. > > Signed-off-by: Ezra Buehler <ezra.buehler@xxxxxxxxxxxxxxxxxx> 1 patch(es) applied to rtw-next branch of rtw.git, thanks. 4828f572b20b wifi: rtl8xxxu: Enable AP mode for RTL8192CU (RTL8188CUS) --- https://github.com/pkshih/rtw.git
