> Device is booted in factory test mode to calibrate the board. > The commands are sent from a userspace application, which is > sent to firmware using wmi commands. Firmware will send the > response back to the application which stores the calibration > data in caldata.bin file. This file will be loaded when the > device boots up normally next time. I would like to calibrate and generate test signals on a QCN9074 chip using the factory test mode. Which userspace application am I supposed to use to perform the calibration and tests? QCN9074 PCI WLAN.HK.2.5.0.1-03982-QCAHKSWPL_SILICONZ-3 Linux Kernel 6.1
