<andrea.marcer@xxxxxxxxxxxxxxxxxxxx> writes: >> Device is booted in factory test mode to calibrate the board. >> The commands are sent from a userspace application, which is >> sent to firmware using wmi commands. Firmware will send the >> response back to the application which stores the calibration >> data in caldata.bin file. This file will be loaded when the >> device boots up normally next time. > > I would like to calibrate and generate test signals on a QCN9074 > chip using the factory test mode. Which userspace application > am I supposed to use to perform the calibration and tests? > > QCN9074 PCI WLAN.HK.2.5.0.1-03982-QCAHKSWPL_SILICONZ-3 > Linux Kernel 6.1 To my knowledge there are no calibration tools publically available, unfortunately. -- https://patchwork.kernel.org/project/linux-wireless/list/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
