Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx> wrote: > New parameter 'single_chip_mlo_support' was added in QMI PHY > capability response message. This is an optional parameter added > in QCN9274 firmware. This parameter states if the firmware > supports Single-Link Operation (SLO) and Multi-Link Operation (MLO) > within the same device. > > If single_chip_mlo_support = 1, then intra device SLO/MLO is supported > in the firmware. > If single_chip_mlo_support = 0, then intra device SLO/MLO is not > supported in the firmware. > > Hence, add support to read 'single_chip_mlo_support' parameter from > the QMI PHY capability response message. > > Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1 > Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00209-QCAHKSWPL_SILICONZ-1 > > Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx> > Signed-off-by: Kalle Valo <quic_kvalo@xxxxxxxxxxx> 2 patches applied to ath-next branch of ath.git, thanks. ae6ec4a38aa4 wifi: ath12k: read single_chip_mlo_support parameter from QMI PHY capability da3cbd88e780 wifi: ath12k: set mlo_capable_flags based on QMI PHY capability -- https://patchwork.kernel.org/project/linux-wireless/patch/20240418125609.3867730-2-quic_rajkbhag@xxxxxxxxxxx/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
