On 3/13/2023 5:51 PM, Kalle Valo wrote: > Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx> writes: > >> Device is booted in factory test mode to calibrate the board. >> The commands are sent from a userspace application, which is >> sent to firmware using wmi commands. Firmware will send the >> response back to the application which stores the calibration >> data in caldata.bin file. This file will be loaded when the >> device boots up normally next time. >> >> Govindaraj Saminathan (1): >> wifi: ath11k: factory test mode support >> >> Sowmiya Sree Elavalagan (1): >> wifi: ath11k: Allow ath11k to boot without caldata in ftm mode > > While reviewing the patches I made quite a few style cleanup to patches > (too many to list): > > https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=4a5ca29c396ace5c46b208a8c15a3ba53eabaddd > > https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=ba74c7478f5d15ce38e609b9ad4810db7511a3dd > > I only compile tested them. Please use these as the baseline for v2. > Hi Kalle, Unable to get the baseline patch for v2 from the above link. Getting the below error with the link: Bad commit reference: 4a5ca29c396ace5c46b208a8c15a3ba53eabaddd
