Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx> writes: > Device is booted in factory test mode to calibrate the board. > The commands are sent from a userspace application, which is > sent to firmware using wmi commands. Firmware will send the > response back to the application which stores the calibration > data in caldata.bin file. This file will be loaded when the > device boots up normally next time. > > Govindaraj Saminathan (1): > wifi: ath11k: factory test mode support > > Sowmiya Sree Elavalagan (1): > wifi: ath11k: Allow ath11k to boot without caldata in ftm mode While reviewing the patches I made quite a few style cleanup to patches (too many to list): https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=4a5ca29c396ace5c46b208a8c15a3ba53eabaddd https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=ba74c7478f5d15ce38e609b9ad4810db7511a3dd I only compile tested them. Please use these as the baseline for v2. -- https://patchwork.kernel.org/project/linux-wireless/list/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
