Device is booted in factory test mode to calibrate the board. The commands are sent from a userspace application, which is sent to firmware using wmi commands. Firmware will send the response back to the application which stores the calibration data in caldata.bin file. This file will be loaded when the device boots up normally next time. Govindaraj Saminathan (1): wifi: ath11k: factory test mode support Sowmiya Sree Elavalagan (1): wifi: ath11k: Allow ath11k to boot without caldata in ftm mode drivers/net/wireless/ath/ath11k/ahb.c | 3 +- drivers/net/wireless/ath/ath11k/core.c | 20 +- drivers/net/wireless/ath/ath11k/core.h | 14 +- drivers/net/wireless/ath/ath11k/debug.h | 2 + drivers/net/wireless/ath/ath11k/mac.c | 13 +- drivers/net/wireless/ath/ath11k/pci.c | 3 +- drivers/net/wireless/ath/ath11k/qmi.c | 10 +- drivers/net/wireless/ath/ath11k/testmode.c | 323 ++++++++++++++++--- drivers/net/wireless/ath/ath11k/testmode.h | 21 +- drivers/net/wireless/ath/ath11k/testmode_i.h | 19 ++ drivers/net/wireless/ath/ath11k/wmi.c | 40 ++- drivers/net/wireless/ath/ath11k/wmi.h | 20 ++ drivers/net/wireless/ath/ath11k/wow.c | 3 +- 13 files changed, 427 insertions(+), 64 deletions(-) base-commit: ddd8e84e007263f3aa8993f32a3dd4dc8ec0876a -- 2.17.1
