On Fri, Jul 22, 2016 at 7:02 PM, Ben Greear <greearb@xxxxxxxxxxxxxxx> wrote: > > > On 07/22/2016 05:21 AM, Krishna Chaitanya wrote: >> >> On Fri, Jul 22, 2016 at 5:29 PM, Manoharan, Rajkumar >> <rmanohar@xxxxxxxxxxxxxxxx> wrote: >>> >>> [...] >>>>>> >>>>>> Thanks Raj, with this fix the rates are 0-7, if i disable then i am >>>>>> seeing 0-9, so its >>>>>> working. >>>>>> >>>>>> But i am seeing a weird issues, the moment i give bitrates command, >>>>>> ath10k no longer does encryption, link is a WPA2-PSK: AES. Even after >>>>>> interface up/down >>>>>> it doesn't work. >>>>> >>>>> After reboot i dont see the "unencrypted" packet issue, i will do >>>>> some more testing on limiting the rates, currently in my setup its >>>>> not reaching MCS9 so cannot verify now. >>>> >>>> Rajkumar, >>>> >>>> I am still not able to make mcs9 work, so i have tried to change the Nss >>>> to 1 >>>> using iw, but that is not taking affect. This command is not taking >>>> effect. >>>> >>> you mean not able to fix VHT rates alone. am i right? By auto rate mode, >>> is firmware selecting >>> mcs9? What is the command used for fixing vht rate? >> >> Basically my requirement is to disable MCS8 and 9 for comparison. >> to check whether ath10k honors the iw command, i used below >> command. changing to 1SS, but i could see that it still transmits >> using 2SS. Does your patch ignore these settings except for >> adhoc mode? >> >> iw set bitrates vht-mcs-5 1:0-7 > > > You can set the number of spatial streams on the phy device. Search around > for a 'chainmask' configurable. > > In general, stock ath10k firmware does not have full support for setting > arbitrary bitrates options. Yes, i know that option but havent tried that. My intention was to limit to MCS7 so in order to verify that commands i tried to change nss. -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
