On 17 October 2013 01:36, Kalle Valo <kvalo@xxxxxxxxxxxxxxxx> wrote:
> ath10k_pci_wait() didn't notify any errors to callers, it
> just printed a warning so add proper error handling.
>
> Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxxxx>
> ---
> drivers/net/wireless/ath/ath10k/pci.c | 28 ++++++++++++++++++++++++----
> 1 file changed, 24 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
> index 1e9cfcc9..92759cd 100644
> --- a/drivers/net/wireless/ath/ath10k/pci.c
> +++ b/drivers/net/wireless/ath/ath10k/pci.c
> @@ -525,15 +525,19 @@ static bool ath10k_pci_target_is_awake(struct ath10k *ar)
> return (RTC_STATE_V_GET(val) == RTC_STATE_V_ON);
> }
>
> -static void ath10k_pci_wait(struct ath10k *ar)
> +static int ath10k_pci_wait(struct ath10k *ar)
> {
> int n = 100;
>
> while (n-- && !ath10k_pci_target_is_awake(ar))
> msleep(10);
>
> - if (n < 0)
> + if (n < 0) {
> ath10k_warn("Unable to wakeup target\n");
> + return -ETIMEDOUT;
> + }
> +
> + return 0;
> }
>
> int ath10k_do_pci_wake(struct ath10k *ar)
> @@ -2227,7 +2231,13 @@ static int ath10k_pci_start_intr_legacy(struct ath10k *ar)
> ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
> PCIE_SOC_WAKE_ADDRESS);
>
> - ath10k_pci_wait(ar);
> + ret = ath10k_pci_wait(ar);
> + if (ret) {
> + ath10k_warn("Failed to enable legacy interrupt, target did not wake up: %d\n",
> + ret);
> + free_irq(ar_pci->pdev->irq, ar);
> + return ret;
> + }
I think we could actually use ath10k_do_pci_wake/sleep() here (see
above iowrite). It does basically the same thing - sets the wake
register and waits until HW wakes up. I think ath10k_pci_wait() could
even go away.
>
> /*
> * A potential race occurs here: The CORE_BASE write
> @@ -2290,6 +2300,10 @@ static int ath10k_pci_start_intr(struct ath10k *ar)
> }
>
> ret = ath10k_pci_start_intr_legacy(ar);
> + if (ret) {
> + ath10k_warn("Failed to start legacy interrupts: %d\n", ret);
> + return ret;
> + }
>
> exit:
> ar_pci->num_msi_intrs = num;
> @@ -2315,13 +2329,19 @@ static int ath10k_pci_reset_target(struct ath10k *ar)
> {
> struct ath10k_pci *ar_pci = ath10k_pci_priv(ar);
> int wait_limit = 300; /* 3 sec */
> + int ret;
>
> /* Wait for Target to finish initialization before we proceed. */
> iowrite32(PCIE_SOC_WAKE_V_MASK,
> ar_pci->mem + PCIE_LOCAL_BASE_ADDRESS +
> PCIE_SOC_WAKE_ADDRESS);
>
> - ath10k_pci_wait(ar);
> + ret = ath10k_pci_wait(ar);
> + if (ret) {
> + ath10k_warn("Failed to reset target, target did not wake up: %d\n",
> + ret);
> + return ret;
> + }
Ditto.
Michał
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
