On 06/17/2013 09:19 AM, Jason Cooper wrote:
Added Franky...
On Wed, Jun 12, 2013 at 06:21:23PM -0400, Jason Cooper wrote:
All,
I have a Seagate Wireless Plus I am trying to put a vanilla kernel on
(currently v3.10-rc5 for various omap DT bits).
I have the board booting and running a debian rootfs on the HD. I just
got mmc to come up and I've discovered that the wireless card is vendor
0x02d0, device 0x4319.
My hope, once I got to this point, was that I would be able to use
the mainline, open source driver. Unfortunately, it looks like brcmfmac
lost support for the 0x4319 while it was in staging.
The commit in question is:
4dad253 staging: brcm80211: remove code for unsupported chip
Is adding it back in a bridge too far?
It looks like only two things are needed, adding the chip id and then
setting the addresses. Here's a preliminary patch to do just that.
Note, the addresses I have used are a straight copy from the 4329. It
causes this:
[ 12.346466] mmcblk mmc0:0001: no of_node; not parsing pinctrl DT
[ 12.353149] brcmfmac_sdio mmc0:0001:1: no of_node; not parsing pinctrl DT
[ 12.360717] brcmfmac_sdio mmc0:0001:2: no of_node; not parsing pinctrl DT
[ 12.368804] brcmfmac: brcmf_sdio_chip_drivestrengthinit: No SDIO Drive strength init done for chip 4319 rev 1 pmurev 7
[ 12.380462] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=03, Err: -22
[ 12.391906] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=03, Err: -22
[ 12.403289] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=03, Err: -22
[ 12.412261] brcmfmac: brcmf_sdio_regrw_helper: failed with -22
[ 12.418457] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=01, Err: -22
[ 12.429718] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=01, Err: -22
[ 12.441101] brcmfmac: brcmf_sdioh_request_byte: Failed to write byte F0:@0x00408=01, Err: -22
[ 12.450073] brcmfmac: brcmf_sdio_regrw_helper: failed with -22
I've taken a quick look at aosp, the provided GPL broadcom code, and I
haven't seen anything for the 4319 wrt to addresses. How hard would it
be to get those addresses from you guys?
Hi Jason,
The major obstacle of adding 4319 support is the obsolete firmware.
Since it's an EOL chip we are not planning to add the support to brcmfmac.
Franky
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
