Hi Chris,
On Fri, Nov 29, 2013 at 12:08 AM, Chris Ruehl <chris.ruehl@xxxxxxxxxxxx> wrote:
> hw_phymode_configure configures the PORTSC registers and allow the
> following phy_inits to operate on the right parameters. This fix a problem
> where the UPLI (ISP1504) could not detected, because the Viewport was not
> available and returns 0's only.
>
> Signed-off-by: Chris Ruehl <chris.ruehl@xxxxxxxxxxxx>
I have already fixed this issue. It is in mainline now:
commit 03779f05be6dfc48de99763f6c845a003e1e40f3
Author: Fabio Estevam <fabio.estevam@xxxxxxxxxxxxx>
Date: Wed Aug 14 12:43:56 2013 +0300
usb: chipidea: move hw_phymode_configure() into probe
Currently hw_phymode_configure() is located inside hw_device_reset(), which
only called by chipidea udc driver.
When operating in host mode, we also need to call hw_phymode_configure() in
order to properly configure the PHY mode, so move this function into probe.
After this change, USB Host1 port on mx53qsb board is functional.
Signed-off-by: Fabio Estevam <fabio.estevam@xxxxxxxxxxxxx>
Tested-by: Arnaud Patard <arnaud.patard@xxxxxxxxxxx>
Reviewed-by: Peter Chen <peter.chen@xxxxxxxxxxxxx>
Signed-off-by: Alexander Shishkin <alexander.shishkin@xxxxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Regards,
Fabio Estevam
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
