On Wednesday 20 November 2013 02:27 PM, Vivek Gautam wrote: > Hi Kishon, > > > On Mon, Nov 11, 2013 at 4:41 PM, Kishon Vijay Abraham I <kishon@xxxxxx> wrote: >> Hi, > sorry for the delayed response. > >> >> On Wednesday 06 November 2013 05:37 AM, Jingoo Han wrote: >>> On Wednesday, November 06, 2013 2:58 AM, Vivek Gautam wrote: >>>> On Tue, Nov 5, 2013 at 5:33 PM, Jingoo Han <jg1.han@xxxxxxxxxxx> wrote: >>> >>> [.....] >>> >>>>> USB3.0 PHY consists of two blocks such as 3.0 block and 2.0 block. >>>>> This USB3.0 PHY can support UTMI+ and PIPE3 interface for 3.0 block >>>>> and 2.0 block, respectively. >>>>> >>>>> Conclusion: >>>>> >>>>> 1) USB2.0 PHY: USB2.0 HOST, USB2.0 Device >>>>> Base address: 0x1213 0000 >>>>> >>>>> 2) USB3.0 PHY: USB3.0 DRD (3.0 HOST & 3.0 Device) >>>>> Base address: 0x1210 0000 >>>>> 2.0 block(UTMI+) & 3.0 block(PIPE3) >>>> >>>> And this is of course the PHY used by DWC3 controller, which works at >>>> both High speed as well as Super Speed. >>>> Right ? >>> >>> Right. >>> >>> While 3.0 block(PIPE3) can be used for Super Speed, 2.0 block(UTMI+) >>> can be used for High speed. >> >> It should then come under *single IP muliple PHY* category similar to what >> Sylwester has done. > > Do you mean that i should be including PHY IDs for UTMI+ phy and PIPE3 > phy present in this PHY block ? > AFAICS the two phys (UTMI+ and PIPE3) do not really have separate > registers to program, and that's the reason > we program the entire PHY in a shot. you mean you program the same set of bits for UTMI+ and PIPE3? Thanks Kishon -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
